26.2. Configuring OProfile
Before OProfile can be run, it must be configured. At a minimum, selecting to monitor the kernel (or selecting not to monitor the kernel) is required. The following sections describe how to use the opcontrol utility to configure OProfile. As the opcontrol commands are executed, the setup options are saved to the /root/.oprofile/daemonrc file.
26.2.1. Specifying the Kernel
First, configure whether OProfile should monitor the kernel. This is the only configuration option that is required before starting OProfile. All others are optional.
To monitor the kernel, execute the following command as root:
opcontrol --setup --vmlinux=/usr/lib/debug/lib/modules/`uname -r`/vmlinux
Note
The debuginfo package must be installed (which contains the uncompressed kernel) in order to monitor the kernel.
To configure OProfile not to monitor the kernel, execute the following command as root:
opcontrol --setup --no-vmlinux
This command also loads the
oprofile kernel module, if it is not already loaded, and creates the
/dev/oprofile/ directory, if it does not already exist. Refer to
Section 26.6, “Understanding /dev/oprofile/ ” for details about this directory.
Note
Even if OProfile is configured not to profile the kernel, the SMP kernel still must be running so that the oprofile module can be loaded from it.
